A353

Endurance Mold Release

Stoner® A353 Endurance Mold Release is specially formulated as a long lasting, non-transferring release agent and anti-stick mold coating for molded rubber and similar materials. Provides a permanent yet removable, thin-layer, anti-stick mold surface coating for fast, easy part removal from molds.  A single application will allow multiple molding cycles. When the mold eventually begins to stick, often the sticking area alone can be “touched-up” quickly and allow continued molding with minimal production delay.  Improves molding efficiency in many processes including injection, compression, and transfer molding. Read DIRECTIONS below before using.

Stoner® A353 ADVANTAGES:

• Saves Time: Parts can be removed quickly and easily from molds
• Cost-Effective: Aerosol dispensers control the particle size, the spray pattern, the volume dispensed and the concentration of the spray for maximum effectiveness
• Increased Productivity: Allows multiple releases per single application
• Improved Quality: Release will not transfer or interfere with the rubber compound
• Enhances Part Appearance: Reduces defects caused by sticking

Stoner® A353 耐力模具脱模剂专门用于模塑橡胶、防粘模具表面涂层和类似材料，提供永久性的效果，快速，轻松地从模具中脱模。单次应用将產生多次模制周期。当模具最终开始粘附时，通常粘附区域可以单独快速地“接触”，并允许以最小的生产延迟继续模制。提高了许多工艺（包括注塑，压缩和传递模塑）的成型效率。

 

Stoner® A353 优点：

• 节省时间：可以快速方便地从模具中取出零件
• 成本效益：气溶胶分配器控制粒度，喷雾模式，分配的体积和喷雾的浓度，以获得最大的效果
• 提高的生产力：允许每次应用将產生多次模制周期
• 提高质量：释放不会转移或干扰橡胶化合物
• 增强零件外观：减少由于粘附引起的缺陷